COMPANY HEADER
Request Information
  • Economical heat sources for several applications
  • No mounting support in stationary systems
2 1/2" - 3" Cold Section - 150 lb. Steel Flange.
Without thermostat.
Unit of Measure

Specifications

Brands

 N/A WATTCO™

National Pipe Thread (NPT) Connection Size

 N/A 1 in

Power

 N/A 3.0 kW

Standard Voltage at Single Phase

 N/A 208 V240 V

Power Density

 N/A 12.4 W/cm²80 W/in²

Sheath Material

 N/A Copper Steel

Screw Plug or Flange Material

 N/A Brass Steel

Vessel Material

 N/A Brass

Heater Type

 N/A MSX

Net Weight

 N/A 13.2 lb6 kg

Construction

Construction

 N/A
  • Basic construction:
    • 1" or 1 1/4" pipe fitted with a pipe "T" to fit a screw plug heater
    • Insulated pipe with 1 1/4"- 1 1/2" of insulation protected by a steel casing of 20 ga.
  • Supplied units:
    • Without thermostats
    • With general-purpose, moisture resistant, or explosion-proof terminal housings
  • If the outlet liquid or gas temperature is above 150ºC (300ºF):
    • Take the farthest end from the terminal box as the outlet
  • If the outlet liquid or gas temperature is under 150 ºC (300 ºF):
    • Take the outside threaded connection as the system inlet

Application

Application

 N/A Water Glycol Water Solutions Low Viscosity Liquids Not Corrosive to Brass or Copper

Features

Features

 N/A
  • Stainless steel wetted parts
  • Moisture resistant or explosion-proof housings
  • Special wattage (length increases when the watt density is the same)
  • Special thermostat range

Note

Note

 N/A Select lower watt density heaters for heavier liquids.
Incoloy® and Inconel® are registered trademarks of Inco Alloys International
When ordering, please specify: Quantity, catalogue number, voltage, phase, wattage, material to be heated, flowing or static mediums, types of controls to be applied, type of metal or alloy of the container, any extra features.